English Chinese

OPERATION & MAINTENANCE

operation manual for skiving machine

1).composition 

Skiving machine includes motor, reducer, electrical box, frame, cage, edge rod support, edge rod, mandrels, mandrel box and pedal.

Mandrels for external skiving:
4/16, 5/16, 3/8, 1/2, 5/8, 3/4, 1, 1 1/4, 1 1/2, 2
Mandrels for internal skiving:5/8, 3/4, 1, 1 1/4, 1 1/2, 2
 

2)operation procedure

1before turn power on

 

(1) Select proper mandrel

(2) mandrel position adjustment

For external skiving, insert the mandrel into edge rod support hole, adjust the mandrel position as skiving length and fixed by bolt

For internal skiving, insert the mandrel into edge rod support hole, adjust the mandrel position by turn the nut as skiving length and fixed by bolt

 (3)edge adjustment

Put the hose onto mandrel, adjust edge rod position and edge position so that the edge touch the hose wire

Put the hose onto internal skiving mandrel edge, unscrew the bolt, adjust the edge touch the hose inner wire and screw the bolt

2Turn power on: plug in 380volt,50HZclose cage till pushing down safety switch and push down the green button
 
3after power on
(1) Before inserting the hose, turn the rotation knob to right hand or left hand, step down pedal, observe the rotation, should be anticlockwise for external skiving, clockwise for internal skiving
(2) After rotation fixed, insert hose, step down pedal and begin skiving, if unsatisfactory, readjust as (2) or (3) procedure
(3) Skiving over, turn rotation knob to neutral, push the red button to power off
3)attention
1dont put hand into cage if cage not opened
2during skiving testing, if edge very near to wire, may cause edge damaged quickly
3if edge worn, grinding edge or replace at once
4if problems occurred, power off firstly
5Handle the rubber collector
Important notice: 380v power, adjust edge and mandrel, close cage, push down proper button, step down pedal to skive